How it works
Measure
Window or rod width, and the finished length from the rod to where the curtain ends.
Pick the fullness
2 to 2.5 times the width suits pencil and pinch pleats; eyelet is about 2 times (one source).
Add hems and repeat
Header and bottom hem add to the length. A pattern repeat rounds the cut length up.
How the widths and the length are counted
Curtains look full because the fabric is wider than the window. The total width of fabric is the window width times the fullness, plus the side hems on every panel. Divide by the usable width of the fabric and round up to a whole number of widths, because you cannot buy a part of a width.
Each width is cut the same length: the finished drop plus the header allowance plus the bottom hem. One reference uses 30 cm (about 12 in) for header and hem together, and says makers differ, so both boxes in the fine-tune section can be changed.
With a pattern, every width must start at the same point in the repeat. The calculator rounds the cut length up to a whole repeat, and that is why patterned curtains need so much more fabric. Fullness and pleat figures come from one readable page, so check the heading tape or pleat maker's instructions before you cut.
Total fabric width by window width
| Window | 1.5× | 2× | 2.5× |
|---|---|---|---|
| 36 in | 54 in | 72 in | 90 in |
| 48 in | 72 in | 96 in | 120 in |
| 60 in | 90 in | 120 in | 150 in |
| 72 in | 108 in | 144 in | 180 in |
| 96 in | 144 in | 192 in | 240 in |
Before side hems. Fullness for 2 to 2.5×: Mill Shop: calculating the cut drop (single source).









