How it works
List the pieces
One line per piece: width × height × how many. Use cut sizes, with seam allowances already added.
Choose the fabric
Pick the bolt width. The usable width is a little less, because the selvedges are cut off.
Set grain, nap and repeat
Plain fabric lets pieces turn. A one-way print keeps them all the same way up, and a pattern repeat rounds the length up.
How the yardage is worked out
Fabric comes in one fixed width and as much length as you buy, so the question is how long a strip of that width the pieces need. The calculator lines the pieces up in rows across the usable width, tallest first, and starts a new row when the next piece no longer fits. The sum of the row heights is the length.
That is a safe amount, not the tightest possible. A person with the pieces laid out on a table can sometimes nest a curved edge or turn a piece to save a few inches. Treat the result as the amount that always works, and buy a little more for a bold print you want to match.
Grain matters for garments: the height of each piece runs down the length of the fabric, so choose "keep the grain" and no piece is turned. For a nap or a one-way print, choose the third option and every piece stays the same way up. A pattern repeat longer than the cut length rounds the total up to a whole repeat, so the motifs line up.
Shrinkage is optional. Switch it on if you have not washed the fabric yet and the amount of shrink is unknown; the tool adds 10 %. A test swatch tells you more than any average.
Shrinkage allowance
| Fabric | Typical shrink | Status |
|---|---|---|
| Cotton | 3 to 5 % | single source |
| Linen | 5 to 10 % | Two sources agree |
| Extra to buy if unwashed | 10 % | One page says 10 %, another ⅛ yd per yard for linen |
Sources: Fabricis shrinkage guide and Stone Mountain fabric care guide. A pre-wash test swatch is better than any average.









